NASCOM DATABOOK 2014
SURFACE MOUNT WIDE GAP SCREW TERMINAL SWITCH SET N85TWG
WIRING SCHEMATIC
NC, OPEN LOOP (WHITE)
SWITCH CONTACT
SWITCH CONTACT
SPDT, SINGLE POLE DOUBLE THROW COMMON (BROWN) NO, CLOSED LOOP (RED)
CLOSED LOOP, NORMALLY OPEN CONTACT
OPEN LOOP, NORMALLY CLOSED CONTACT
DIMENSIONS - IN [mm]
2.585 65.66 2.140 54.36
2.140 54.36 2.585 65.66
2.585 65.66 2.140 54.36
.265 6.73
.525 13.34
.140 3.56
.264 6.71
TOP VIEW
.125 3.18
.475 12.07
END VIEW
.525 13.34
.525 13.34
FRONT VIEW
.140 3.56
.215 5.46
.140 3.56
.165
TOP VIEW
TOP VIEW
TOP VIEW
4.19
.425 10.80
END VIEW
FRONT VIEW
.125 3.18
.125 3.18
2.585 65.66
.475 12.07
.751 19.06
TOP VIEW
.475 12.07
FRONT VIEW
FRONT VIEW
END VIEW
FRONT VIEW
SWITCH
MAGNET
SPACER
INSTALLATION INSTRUCTIONS Note: High Security model – Dots on switch and magnet must be aligned for correct operation.
• Position the switch on the door/window frame in the desired location as close to the movable part of the door /window as possible. • Mark the switch mounting screw locations and drill the mounting screw holes using a drill adequately sized for #6 self-tapping screws. • Install screws and tighten to mount the switch on the door/window frame. • Position the magnet on the movable part of the door/window, align the magnet with the switch as close as possible. For steel door or window applications, use the enclosed spacer under the magnet. • Mark the magnet mounting screw locations and drill the mounting screw holes using a drill adequately sized for #6 self-tapping screws. • Install screws and tighten to mount the magnet on the door/window.
• Connect the alarm circuit leads to the terminals on the switch and test the system for correct operation. • Loosen the switch mounting screws and install terminal screw cover. Retighten mounting screws.
Royne Industries LLC, dba NASCOM | P: 800.843.5530 | F: 800.727.4041 | www.nascominc.com 2 DWG No. 131122-22 Rev. 1
Made with FlippingBook