NASCOM DATABOOK 2014
3/4” RECESSED STUBBY DOOR CONTACT WITH SHARK MAGNET N1178C SHK
WIRING SCHEMATIC
SWITCH CONTACT
SWITCH CONTACT
CLOSED LOOP, NORMALLY OPEN CONTACT
OPEN LOOP, NORMALLY CLOSED CONTACT
DUAL CLOSED LOOP, NORMALLY OPEN CONTACTS
NC, OPEN LOOP (WHITE) NC, OPEN LOOP (RED) NC, OPEN LOOP (WHITE) NO, CLOSED LOOP (RED)
COMMON (BROWN) COMMON (BROWN)
NC, OPEN LOOP (WHITE) NO, CLOSED LOOP (RED)
COMMON (BROWN)
DPDT, DOUBLE POLE DOUBLE THROW
SPDT, SINGLE POLE DOUBLE THROW
DIMENSIONS - IN [mm]
.910 23.11
.730 18.54
1.600 40.64
TOP VIEW
.480 12.19
1.507 38.27
FRONT VIEW
.800 20.32
.375 9.53
1.119 28.42
.060 1.52
.375 9.53
SWITCH
MAGNET
INSTALLATION INSTRUCTIONS • Mark location for the switch on the door frame. • Drill a hole for the switch using a 3/4” Hole Saw for steel doors or a Forstner bit for wood doors. • Connect the switch leads to the alarm circuit conductors. Hold the wire leads (not the switch housing) when cutting and stripping to prevent damage to the switch. • Feed the switch conductors into the hole and insert the switch housing pressing firmly until seated. Silicone may be used to secure the switch in wood doors. • Test switch for correct operation and make sure gap performance is acceptable. • Place a mark on the top edge of the door aligned with the center of the switch. • Press the springs inward on the sides of magnet. • Insert the magnet in u-channel in the top of the door centered with the alignment mark. • Release the springs to secure the magnet and complete the installation.
Royne Industries LLC, dba NASCOM | P: 800.843.5530 | F: 800.727.4041 | www.nascominc.com 2 DWG No. 131125-06 Rev. 1
Made with FlippingBook